Engine mounting - RH (page 2 of 2)

ENGINE - V8

12-2-52 REPAIRS

10. Fit LRT-12-216 to engine lifting eyes.

11. Remove nut securing RH engine mounting to 

engine mounting bracket.

12. Remove nut securing LH engine mounting to 

engine mounting bracket.

13. Connect chain to engine lifting bracket and 

raise engine sufficiently only to clear mounting.

CAUTION: To prevent damage to the 
radiator, guide the fan cowl clear of the 
radiator as it is raised with the engine.

14. Remove 2 bolts securing RH engine mounting 

to sub-frame, discard bolts.

15. Remove RH engine mounting.

NOTE: The RH engine mounting is removed 
from underneath the vehicle between the 
gearbox bell housing and the sub-frame.

Refit

1. Clean engine mountings and mating faces.
2. Fit RH engine mounting to sub-frame and 

tighten new bolts to 56 Nm (41 lbf.ft).

3. Lower engine onto engine mountings.

NOTE: Guide the fan cowl into position as the 
engine is lowered.

4. Remove engine lifting chains.
5. Fit 2 nuts securing engine mountings to engine 

mounting brackets and tighten to 100 Nm (74 
lbf.ft).

6. Remove engine lifting bracket.
7. Fit fan cowl to radiator and fit securing scrivets.
8. Fit auxiliary cooling fan multiplug to fan cowl.
9. Fit screw securing fan cowl to radiator.

10. Fit undertray.

 + 

 EXTERIOR FITTINGS, REPAIRS, 

Undertray - front.

11. Connect air intake hose.

 + 

 ENGINE MANAGEMENT SYSTEM - 

V8, REPAIRS, Hose - air flow meter to 
throttle body.

12. Fit air intake plenum.

 + 

 HEATING AND VENTILATION, 

REPAIRS, Plenum - air intake.

13. Connect battery earth lead.