Power steering pressure test - Td6
- Make
- Land Rover
- Model
- Range Rover L322 Range Rover Service Procedures
- Section
- ADJUSTMENTS › Power steering pressure test - Td6
STEERING
57-4
ADJUSTMENTS
27. Loosen track rod end locknut.
28. Adjust by rotating track rod using hexagon on
shaft. Do not allow gaiter to twist.
CAUTION: Both track rods must be rotated
an equal amount.
29. Recheck front wheel alignment.
30. Tighten track rod end locknut to 55 Nm (40
lbf.ft).
31. Connect battery earth lead.
Power steering pressure test - Td6
$% 57.90.10.01
Before disconnecting the battery, ensure all text and
cautions in the battery disconnection section are
observed.
GENERAL INFORMATION, Electrical
Check
1. Disconnect battery earth lead.
2. Siphon PAS fluid from reservoir.
3. Position absorbent cloth to catch spillage.
4. Loosen union securing high pressure pipe to
PAS pump and release pipe.
CAUTION: Care must be taken to ensure
that oil or fluid does not enter or
contaminate the alternator.
5. Fit adaptor LRT-57-034A to high pressure port
of PAS pump.
Parts & tools for this job Staging For Land Rover Range Rover
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Land Rover power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.