Supplementary restraint system precautions (page 4 of 7)

GENERAL INFORMATION

03-23

WARNING: For front seat buckle type pre-
tensioners, hold by the piston tube, with the open 
end of the piston tube pointing towards the 
ground and the buckle facing away from your 
body. Do not cover the end of the piston tube.  
DO NOT hold buckle pre-tensioners by the 
bracket assembly or steel cable. NEVER point 
the piston tube towards your body or other 
people.

CAUTION: Do not apply grease or cleaning 
solvents to seatbelt pre-tensioner units, 
component failure could result.

Storage

There are regulations for the safe storage of SRS 
components which must be observed, consult your 
local authority for details.

WARNING: Airbag modules and seat belt pre-
tensioners are classed as explosive devices. For 
overnight and longer term storage, they must be 
stored in a secure steel cabinet which has been 
approved as suitable for the purpose and has 
been registered by the local authority.

WARNING: Store the airbag module with the 
deployment side uppermost. If it is stored 
deployment side down, accidental deployment 
will propel the airbag module with enough force 
to cause serious injury.

CAUTION: Improper handling or storage can 
internally damage the airbag module, making it 
inoperative. If you suspect the airbag module has 
been damaged, install a new module and refer to 
the Deployment/Disposal Procedures for 
disposal of the damaged module.

Always observe the following precautions when 
temporarily storing an airbag module:

l

Ensure the cover is facing upwards and the 
luggage compartment is  secured.

l

Always keep components cool, dry and free 
from contamination.

l

Do not allow anything to rest on the airbag 
module.

l

Store any removed airbag assembly on a 
secure flat surface away from electrical 
equipment and heat sources (exceeding 85

°

 C 

(185

°

 F).