Selector cable - adjust (AUTOMATIC GEARBOX - JATCO)

AUTOMATIC GEARBOX - JATCO

ADJUSTMENTS

44-3

Selector cable  -  adjust

$% 44.30.04

Adjust

1. Remove underbelly panel.

 + 

 EXTERIOR FITTINGS, REPAIRS, 

Panel - underbelly.

2. Loosen trunnion nut securing inner cable to 

selector lever.

3. Move gear change lever into 'P' position.
4. Move selector lever on gearbox fully clockwise 

to engage 'P' position.

5. Pull inner cable as far forward as possible, then 

release. This will remove any backlash from the 
cable.

6. Tighten trunnion nut to 6 Nm (4 lbf.ft).
7. Fit underbelly panel.

 + 

 EXTERIOR FITTINGS, REPAIRS, 

Panel - underbelly.

8. Move selector lever through its working arc; 

from 'P' to '2' and back to 'P', checking that all 
gear positions are correctly selected.

9. Check that the engine will start in 'P' and 'N' 

positions and is inhibited when drive positions 
are selected.

M44 1640