Workshop Manuals Factory service & repair Land Rover
01 Discovery Workshop Manual - 2nd Edition02 01 - INTRODUCTION03 04 - GENERAL SPECIFICATION DATA04 05 - ENGINE TUNING DATA05 07 - GENERAL FITTING REMINDERS06 09 - LUBRICANTS, FLUIDS AND CAPACITIES07 10 - MAINTENANCE08 12 - ENGINE - Tdi09 10 11 12 12 - ENGINE - V8i13 12 - ENGINE - 4.0 V814 12 - ENGINE - Mpi15 16 17 18 17 - EMISSION CONTROL19 19 - FUEL SYSTEM - Tdi20 19 - FUEL SYSTEM - MFI21 19 - FUEL SYSTEM - SFI22 19 - FUEL SYSTEM - Mpi23 19 - FUEL SYSTEM - Cruise Control24 26 - COOLING SYSTEM - Tdi25 26 - COOLING SYSTEM - V8i26 26 - COOLING SYSTEM - Mpi27 28 30 - MANIFOLD AND EXHAUST SYSTEM29 33 - CLUTCH30 37 - MANUAL GEARBOX - R38031 41 - TRANSFER GEARBOX32 44 - AUTOMATIC GEARBOX - ZF33 34 35 47 - PROPELLER SHAFTS36 51 - REAR AXLE AND FINAL DRIVE37 38 54 - FRONT AXLE AND FINAL DRIVE39 40 41 57 - STEERING42 43 44 60 - FRONT SUSPENSION45 64 - REAR SUSPENSION46 70 - BRAKES47 74 - WHEELS AND TYRES48 75 - SUPPLEMENTARY RESTRAINT SYSTEM49 76 - CHASSIS AND BODY50 51 80 - HEATING AND VENTILATION52 82 - AIR CONDITIONING53 84 - WIPERS AND WASHERS54 86 - ELECTRICAL
Land Rover 300Tdi Discovery47 · 74 - WHEELS AND TYRES
47 · Steering & suspension

TYRE PRESSURES

Make
Land Rover
Model
Discovery 300Tdi Discovery
Section
REPAIR › TYRE PRESSURES
74 - WHEELS AND TYRESTYRE PRESSURES
background image

74

WHEELS AND TYRES

2

REPAIR

When the indicators appear in two or more adjacent
grooves, at three locations around the tyre, a new tyre
must be fitted.

NOTE: Do not attempt to interchange
tyres, e.g. from front to rear, as tyre wear
produces characteristic patterns

depending on their position. If tyre position is
changed after wear has occured, the performance
of the tyre will be adversely affected.

NOTE: Territorial vehicle regulations
governing tyre wear MUST be adhered to.

WHEELS INSPECTION

Regularly check the condition of the wheels. Replace
any wheel that is bent, cracked, dented or has
excessive runout.

VALVES INSPECTION

Check condition of inflation valve. Replace any valve
that is worn, cracked, loose, or leaking air.

TYRE PRESSURES

Maximum tyre life and performance will be
obtained only if tyres are maintained at the correct
pressures.

Tyre pressures must be checked at least once a
month and at least once a week, preferably daily, if
the vehicle is used off road.

The tyre inflation pressure is calculated to give the
vehicle satisfactory ride and steering characteristics
without compromising tyre tread life. For
recommended tyre pressures in all conditions.

See

GENERAL SPECIFICATION DATA, Information,
Wheels and Tyres

American vehicles - A label attached to the inside
edge of the driver’s door also provides tyre pressure
information.

Always check tyre inflation pressures using an
accurate gauge and inflate tyres to the
recommended pressures only.

Check and adjust tyre pressures ONLY when the
tyres are cold, vehicle parked for three hours or more,
or driven for less than 3.2 km (2 miles) at speeds
below 64 km/h (40 mph). Do not reduce inflation
pressures if the tyres are hot or the vehicle has been
driven for more than 3.2 km (2 miles) at speeds over
64 km/h (40 mph), as pressures can increase by 0.41
bars (6 p.s.i) over cold inflation pressures.

Check ALL tyre pressures including the spare. Refit
the valve caps as they form a positive seal and keep
dust out of the valve.

Parts & tools for this job Staging For Land Rover Discovery

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.