EXHAUST PIPE HEAT SHIELD - R R

Operation 1076A40 · EXHAUST PIPE FASTENINGS AND PROTECTIONS

2.2 16V JTD

Removing

- Position the vehicle on a lift.

See in Op. 1076B20

1. Using a drill fitted with a suitable size helical point, drill out and remove the fastening rivets.

2. Remove the front section of the exhaust pipe heat shields.

1. Undo the nut (1a) and, using a drill fitted with a suitable size helical point, drill out and remove the fastening rivets (1b).

2. Remove the rear section of the exhaust pipe heat shield.

Refitting

- Place the rear heat shield in its housing and secure it using the fixing nut.

- Refit the rivets using a riveter.

- Fit the front shield and refit the rivets using a riveter.

See in Op. 1076B20

- Remove the vehicle from the lift.

2.0 16v

Removing

- Position the vehicle on a lift.

See in Op. 1076B10

1. Using a drill fitted with a suitable size helical point, drill out and remove the fastening rivets.

2. Remove the front section of the exhaust pipe heat shields.

1. Undo the nut (1a) and, using a drill fitted with a suitable size helical point, drill out and remove the fastening rivets (1b).

2. Remove the rear section of the exhaust pipe heat shield.

Refitting

- Place the rear heat shield in its housing and secure it using the fixing nut.

- Refit the rivets using a riveter.

- Fit the front shield and refit the rivets using a riveter.

See in Op. 1076B10

- Remove the vehicle from the lift.

2.0 16V JTD

Removing

- Position the vehicle on a lift.

See in Op. 1076B10

1. Using a drill fitted with a suitable size helical point, drill out and remove the fastening rivets.

2. Remove the front section of the exhaust pipe heat shields.

1. Undo the nut (1a) and, using a drill fitted with a suitable size helical point, drill out and remove the fastening rivets (1b).

2. Remove the rear section of the exhaust pipe heat shield.

Refitting

- Place the rear heat shield in its housing and secure it using the fixing nut.

- Renew the rivets using a riveter.

- Fit the front shield and renew the rivets using a riveter.

See in Op. 1076B10

- Remove the vehicle from the lift.

3.0 24V V6

Removing

- Position the vehicle on a lift.

Op. 1076B10 EXHAUST PIPE ASSEMBLY - R + R

1. Using a drill fitted with a suitable size helical bit, drill and remove the fastening rivets.

2. Remove the front section of the exhaust pipe heat shields.

1. Undo the nut (1a), using a drill fitted with a suitable size helical bit, drill and remove the fastening rivets (1b).

2. Remove the rear section of the exhaust pipe heat shield.

Refitting

- Place the rear heat shield in its housing and secure it using the fixing nut.

- Renew the rivets using the special tool.

- Fit the front heat shield and renew the rivets using the special tool.

Op. 1076B10 EXHAUST PIPE ASSEMBLY - R + R

- Remove the vehicle from the lift.