Timing CHAIN TENSIONER PLATE - R.R.
- Make
- Lancia
- Model
- Ypsilon Factory Service Manual
- Year
- 2003–2011
- Section
- Timing system › Timing CHAIN TENSIONER PLATE - R.R.
Timing CHAIN TENSIONER PLATE - R.R.
Removing
Position the vehicle on the ramp.
Make sure that the ignition key is in the OFF position; then disconnect the battery negative (-) terminal.
| Name | Connector | |
|---|---|---|
| Battery | A1B |
Drain the air conditioner coolant circuit - 0010T84 coolant for air conditioning system dehydrate and recharge.
Proceed with removal - 4450B04 right front wheel r r.
Proceed with removal - 7055B66 Engine compartment DUST SHIELD protection in right front wheel arch - R.R..
Proceed with removal - 7055B91 Right front WHEEL ARCH LINER - R.R..
Proceed with removal - 1092G10 single engine belt r r.
Proceed with removal - 1092A10 Crankshaft services PULLEY - R.R..
Proceed with removal.
Proceed with removal - 2110A60 manual gearbox/engine coupling bracket - r+r.
Proceed with removal - 1020A20 crank case oil sump - r + r clean seals for sealant application.
Proceed with removal - 1020B10 cover of timing system with chain drive - r + r replace oil seal and gasket.
Proceed with removal - 1032A12 CHAIN AND GEARS for timing system - R.R. for timing or Replacement..
PROCEED AS FOLLOWS FOR THE MOBILE PAD
1. Withdraw pin (1a)a nd remove the mobile pad of timing chain (1b).
PROCEED AS FOLLOWS FOR THE FIXED PAD
1. Undo the bolts (1a) and remove the timing belt fixed pad (1b).
Refitting
PROCEED AS FOLLOWS FOR THE FIXED PAD
Refit the fixed timing belt pad in its seat and secure with bolts.
PROCEED AS FOLLOWS FOR THE MOBILE PAD
Refit the mobile timing belt pad in its seat and secure with bolts.
Proceed with refitting - 1032A12 CHAIN AND GEARS for timing system - R.R. for timing or Replacement..
Proceed with refitting - 1020B10 cover of timing system with chain drive - r + r replace oil seal and gasket.
Proceed with refitting - 1020A20 crank case oil sump - r + r clean seals for sealant application.
Proceed with refitting - 2110A60 manual gearbox/engine coupling bracket - r+r.
Proceed with refitting - 1092A10 Crankshaft services PULLEY - R.R..
Proceed with refitting - 1092G10 single engine belt r r.
Proceed with refitting - 7055B91 Right front WHEEL ARCH LINER - R.R..
Proceed with refitting - 7055B66 Engine compartment DUST SHIELD protection in right front wheel arch - R.R..
Proceed with refitting - 4450B04 right front wheel r r.
Connect the negative (-) battery terminal.
Refill the engine oil lubrication system - 0010T11 engine oil check level and top up.
Refill the engine cooling system with coolant - 0010T20 coolant change.
Fill the air conditioner coolant circuit - 0010T84 coolant for air conditioning system dehydrate and recharge.
Proceed with refitting.
Remove the car from the ramps.
Parts & tools for this job Staging For 2003 Lancia Ypsilon
- PARTTiming belt kitSearch: Lancia Ypsilon 2003 timing belt kit
- TOOLEngine timing tool setSearch: Lancia engine timing tool set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.