Engine oil pressure warning light SWITCH - R.R.

Operation 1084A42 · INDICATORS/CHECK DEVICES

2.4 JTD 20V

Removing

- Position the vehicle on a lift.

- Disconnect the negative battery terminal.

- Raise the lift.

See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.

1. Disconnect the electrical connection for the switch.

2. Undo and remove the engine oil pressure warning light switch.

Refitting

- Fit the engine oil pressure warning light switch.

- Connect the electrical connection.

See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.

- Lower the lift.

- Connect the negative battery terminal.

- Remove the vehicle from the lift.

2.4 20V

Removing

- Position the vehicle on a lift.

- Make sure that the ignition key is in the OFF position, then disconnect the negative battery terminal.

See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.

1. Remove the air intake chamber mounting bracket (1a) acting on the bolt (1b) and the nut (1c).

1. Disconnect the electrical connection from the engine oil pressure warning light switch.

2. Undo and remove the engine oil pressure warning light switch.

Refitting

- Position the engine oil pressure warning light switch and tighten it to the recommended torque.

- Connect the electrical connection.

- Fit the intake chamber mounting bracket.

See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.

- Connect the negative battery terminal.

- Remove the vehicle from the lift.

3.0 V6, 3.2 V6

Removing

- Position the vehicle on a lift.

- Open the boot and disconnect the negative battery terminal.

See in Op. 4450B04 Right FRONT WHEEL (one) - R.R.

See in Op. 7055B64 Engine compartment DUST SEAL in front wheel arch (one), left or right - R.R.

1. Disconnect the electrical connection for the switch.

2. Using a 21 mm 235 1/2" L USAG bush (or an equivalent tool), undo the sensor and remove it.

Refitting

- Tighten the sensor to the recommended torque.

- Connect the electrical connection for the switch.

See in Op. 7055B64 Engine compartment DUST SEAL in front wheel arch (one), left or right - R.R.

See in Op. 4450B04 Right FRONT WHEEL (one) - R.R.

- Connect the negative battery lead, then close the boot.

- Remove the vehicle from the lift.

2.4 JTD 10V

Removing

- Position the vehicle on a lift.

- Disconnect the negative battery terminal.

- Raise the lift.

See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.

1. Disconnect the electrical connection for the switch.

2. Undo and remove the engine oil pressure warning light switch.

Refitting

- Fit the engine oil pressure warning light switch.

- Connect the electrical connection.

See in Op. 7055B54 PROTECTION/GUARD under engine - R.R.

- Lower the lift.

- Connect the negative battery terminal.

- Remove the vehicle from the lift.