Switch on brake pedal - r+r

Operation 1060D38 · Electronic diesel injection control

Removing

Disconnect the battery negative terminal.

1. Disconnect the electrical connection from the switch on the brake pedal.

2. Undo and remove the brake pedal switch.

Refitting

Move the brake pedal to the end of its travel.

Fit the switch onto the bracket, rotating it about 60° clockwise until you hear a click, which means it has attached to the fitting on the bracket.

Release the brake pedal so the servobrake push rod is in rest position.

Check the brake switch is correctly fitted (fully back). If not the brake pedal may remain activated, which could cause the brakes to lock.

Move the pedal to the end of its travel to settle the switch in its housing.

Check there is clearance between the brake bracket and the switch.

Connect the electrical connection

Connect the battery negative terminal.