23 · Diagnostics

Alarm led not working

Fault diagnosisAlarm led not working

ALARM LED NOT WORKING

1.9 JTS, 2.2 JTS, 3.2 JTS, 1.9 JTD 8V, 1.9 JTD 16V, 2.4 JTD 20V

When the alarm is activated, the control LED does not switch off

1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
		Test results
	Connect the diagnostic equipment (Examiner Plus or Smart) and check that there are no faults in the system	End of diagnosis	There are faults present	Move on to Step 2
2	ACTIVE DIAGNOSIS WITH DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Using the diagnostic equipment carryout the active diagnosis of the LED activation	End of diagnosis	The LED is not activated	Move on to Step 3
3	CHECK THE WIRING	All OK	Problems encountered	Operation
	Check the continuity and insulation of the wiring between the Body Computer and the door panel Check that the supply for the LED leaves the Body Computer and that the LED comes on See E7015 ALARM	End of diagnosis	The supply for the LED does not leave the Body Computer	Replace Body Computer Op. 5505A32 BODY COMPUTER - R.R
		End of diagnosis	The supply is sent from the Body Computer but the LED does not light up	Replace the LED.

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.