Engine cooling tank - r + r

Operation 1088B10 · ENGINE COOLING RADIATOR

1.3 JTD

Removing

Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).

1. Disconnect the electrical connection from the air flow meter.

2. Loosen the band and disconnect the the turbocharger air inlet sleeve from the rigid pipe, air flow meter side.

1. Remove the air filter (1a) complete with air flow meter (1b) by releasing from the underlying pins and then from the rear fastenings.

Draw off coolant from the engine coolant tank using a suitable syringe.

1. Disconnect the quick-release fitting of the coolant return pipe from the engine coolant reservoir.

2. Loosen the band and disconnect the supply pipe, engine side.

3. Undo the nuts (3a) and remove the engine coolant tank (3b) with system supply pipe.

Refitting

Refit the coolant reservoir with system supply pipe in its seating and secure with its nuts.

Connect the supply pipe, engine side and tighten the band.

Connect the quick-release fitting on the coolant return pipe to the engine coolant reservoir.

Refill the engine cooling system with coolant - 0010T20 coolant change.

Replace the air filter, complete with air flow meter, in its housing.

Connect the air intake sleeve to the turbocharger, air flow meter side, and tighten the band.

Connect the electrical connection to the air flow meter.

Connect the negative (-) battery terminal.