Cam angle sensor - r r

Operation 1060G22 · Pressure pump electric control

1.3 JTD

Removing

Position the vehicle on the ramp.

Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).

1. Disconnect the electrical connection from the air flow meter.

2. Loosen the band and disconnect the the turbocharger air inlet sleeve from the rigid pipe, air flow meter side.

1. Remove the air filter (1a) complete with air flow meter (1b) by releasing from the underlying pins and then from the rear fastenings.

1. Disconnect the electrical connection from the cam angle sensor.

2. Undo the bolt (2a) and remove the cam angle sensor (2b).

Refitting

Place the cam angle sensor back in its housing and fix it using the bolt to the specified torque.

Connect the electrical connection to the cam angle sensor.

Replace the air filter, complete with air flow meter, in its housing.

Connect the air intake sleeve to the turbocharger, air flow meter side, and tighten the band.

Connect the electrical connection to the air flow meter.

Connect the negative (-) battery terminal.

Remove the car from the ramps.