Fuel pressure sensor - r r

Operation 1060G28 · Pressure pump electric control

1.3 JTD

Removing

Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).

1. Disconnect the electrical connection from the air flow meter.

2. Loosen the band and disconnect the the turbocharger air inlet sleeve from the rigid pipe, air flow meter side.

1. Remove the air filter (1a) complete with air flow meter (1b) by releasing from the underlying pins and then from the rear fastenings.

1. Disconnect the electrical connection from the fuel pressure sensor.

2. Undo and remove the fuel pressure sensor.

Refitting

1. Refit the fuel pressure sensor and tighten it to the specified torque.

2. Connect the electrical connection to the fuel pressure sensor.

Replace the air filter, complete with air flow meter, in its housing.

Connect the air intake sleeve to the turbocharger, air flow meter side, and tighten the band.

Connect the electrical connection to the air flow meter.

Connect the negative (-) battery terminal.