Introduction - ACCESSORIES

Specifications

There are two system configuration levels: 'CD PLAYER, 'CD PLAYER with MP3'.

CD PLAYER

Dimensions: 1 DIN box with 2 DIN front panel

Modules included:

• Radio
• Audio CD player + CD ROM with MP3 (if present)
• LCD graphic display
• External CD CHANGER management (if fitted).

CD PLAYER

Examples showing the disply of the various radio CD functions are illustrated below:

CD PLAYER

Examples showing the disply of the various radio CD with MP3 functions are illustrated below:

OPERATION

The table below describes all the functions that can be activated for both models.

The techincal specifications valid for both models are listed below.

Anti-theft code

The radio is installed during Production and connected t to the CAN to establish communication with the Body Computer. The Body Computerstores an antitheft key known as the Exchange Code.

At each subsequent key on (or if the battery is disconnected), an automatic authenticationprocedure is repeated. The radio display shows the message CANCHECK: if the Exchange Code check is postive, the system begins to operate. If the comparison codes are not the same, the display shows a message that asks the user to entera manual code (Master Code - 4-figure code from 1111 to 6666) shown on the radio code card.

The Master Code is preprogrammed in production and is different for each radio. It is also different from the Exchange Code.

Operation at Key Off

If the radio is on when the key is turned off, it goes off automatically after 20 minutes. It can also be kept on for a further 20 minutes by pressing the ON button again.

Connectors

Rear view:

A - Supply connector

B - Speaker output connector

C - Functions connector

D - Aerial

E - 10 A fuse

Connectors

Connector A Pin Out:

Connector B pinout:

Connector C:

Both models CD and CD+MP3 have input protection for polarity inversion (pins A4 and A8) and protection for the final speaker stage against short circuiting and overheating (pins B1 and B8).

BOSE System

Specifications

A 'Bose' HI FI system with special speakers and an outside amplifier is available on request.

The system has been developed ad hoc for the vehicle: the acoustic properties of the passenger compartment have been carefully studied so that the amplifier and the speakers are perfectly suited to the vehicle: the sound is excellent throughout the passenger compartment.

In addition, the system blends in perfectly with the aesthetics of the vehicle, without taking up extra space.

The system is installed in the vehicle directly in production, without any operations afterwards: the cables are incorporated in the vehicle wiring.

It is therefore advisable not to modify the original system in any way (e.g. graphic equalizers, additional sub-woofers, extra amplifiers).

In addition, the system components (amplifier and speakers) should not be repaired individually, but can only be replaced with new components.

Performance

The Bose system guarantees the highest quality sound, with crystal clear high notes and deep, rich low tones.

With the following specifications:

• Volume compensation, through the 'active' Bose equalizing
• High/low tone control, from + 6dB to - 12 dB
• Fader control, through the Bose 'spatial' fader

COMPOSITION

Unlike the system fitted as standard, the Bose systme includes:

• front speakers specific coaxial type and rear mid-woofer type
• rear sub-woofer speaker in the special bassbox
• high power amplifier

The other components (radio, aerial, etc.) are the same as those on the system fitted as standard.

Location

The diagram below illustrates the location of the components.

1 - Radio

2 - Front door speakers

3 - Rear speakers

4 - Rear sub-woofer speaker

5 - Amplifier

SPECIFCATIONS

Bose amplifier:

SPECIFCATIONS

This is a 6 channel, hi-fi amplifier with 150W power with 6 low distorstion linear digital amplifiers.

The amplifier has 4 stereo channels for the speakers in the front and rear doors and two channels for the dual mobile coil sub-woofer in the rear bassbox.

The amplifier is equipped with a built in equalizer and compressor.

The high resolution equalizer is specially calibrated in the vehicle passenger compartment because it takes into account the vehicle absorption and reflection surfaces (seats, windows, dashboard, door panels) and the position of the speakers and the passengers.

The 'one stage' technology allows high power with compact dimensions and reduced heat emissions compared with conventional linear amplifiers.

The amplifier is fitted with:

• an integrated signal processor, which actively adapts the bass;
• an active equalizer, with automatic electronic balancing of all outputs
• an integrated compressor which minimizes distortions

SPECIFCATIONS

Pinout

Specifications

This is a high fidelity dual coil woofer speaker with a special bass box incorporated which diffuses the sound in an optimum manner preventing vibrations and interference.

Specifications