Brake pedal - r+r manual gearbox versions

Operation 3330B22 · Pedal unit

Removing

Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).

Proceed with removal - 7040A30 Left instrument panel lower TRIM - R.R..

Undo both bolts and remove the underfacia beam lower reinforcement.

1.2 8v, 1.2 16v, 1.4 16v

Proceed with removal - 5550D10 brake light switch - r+r.

1.3 JTD

Proceed with removal - 1060G38 brake pedal switch - r r.

1. Working at the rear of the brake pedal, press the white coloured retaining tabs (1a) which secure the brake servo push rod (1b) to the brake pedal (1c).

1. Remove the black coloured retaining device (1a), then release the brake servo push rod (1b) from the brake pedal (1c) and keep the cover (1d) for the brake servo push rod spherical head seat.

After each dismantling operation the black coloured retaining device (1a) for the brake servo push rod must always be replaced even if it appears to be intact.

1. Remove the stop clip (1a), withdraw the bolt (1b) and remove the brake pedal (1c).

All versions

Refitting

Refit in its seating the brake pedal, then secure it with the bolt and retaining clip.

1. Fit the new retaining device (1a) onto brake pedal (1b) to secure the retaining clips (1c). Position the cover (1d) for the brake servo push rod spherical head.

After each dismantling operation the black coloured retaining device (1a) for the brake servo push rod must always be replaced even if it appears to be intact.

Lift up the brake pedal and position the brake servo push rod by the retaining device.

Press the brake pedal to engage the brake servo push rod with the retaining device.

1.3 JTD

Proceed with refitting - 1060G38 brake pedal switch - r r.

1.2 8v, 1.2 16v, 1.4 16v

Proceed with refitting - 5550D10 brake light switch - r+r.

Refit the underfacia beam lower reinforcement and tighten the bolts

Proceed with refitting - 7040A30 Left instrument panel lower TRIM - R.R..

Connect the negative (-) battery terminal.