Anti-roll bar JOINT - R.R.
- Make
- Lancia
- Model
- Thesis Factory Service Manual
- Year
- 2002–2009
- Section
- Front suspension › Anti-roll bar JOINT - R.R.
‹ Prev Front suspension stabilizer bar - r+r - check wheel geometry separatelyNext › Front suspension FRAME - R.R.
Suspension and wheelsAnti-roll bar JOINT - R.R.
Anti-roll bar JOINT - R.R.
Removing
- Position the vehicle on a lift.
See in Op. 4450B04 Right FRONT WHEEL (one) - R.R.
1. Undo the nuts fixing the joint to the anti-roll bar and to the selector fork.
2. Separate the track rod ends (2a) from the anti-roll bar and from the housing in the selector fork, then remove the joint (2b).
Refitting
- Fit the joint fitting the two ends in the housing in the anti-roll bar and in the selector fork.
- Tighten the fixing nuts to torque.
| Value - daNm | Fastening | Component | Ø | |
|---|---|---|---|---|
| 5.5 | Nut | FRONT ANTI-ROLL BAR JOINTS | M10 X 1.25 |
| Value - daNm | Fastening | Component | Ø | |
|---|---|---|---|---|
| 5.5 | Nut | FRONT ANTI-ROLL BAR JOINTS | M10 X 1.25 |
See in Op. 4450B04 Right FRONT WHEEL (one) - R.R.
- Remove the vehicle from the lift.
‹ Prev Front suspension stabilizer bar - r+r - check wheel geometry separatelyNext › Front suspension FRAME - R.R.
Parts & tools for this job Staging For 2002 Lancia Thesis
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTFront shock absorbersSearch: Lancia Thesis 2002 front shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.