SUPPLY PIPE FROM (PUMP) - MASTER CYLINDER R.R.

Operation 1820B49 · HYDRAULIC CLUTCH SYSTEM

2.0 16V JTD, 2.2 16V JTD

Removing

Op. 5010B18 CLIMATE CONTROL UNIT AIR INTAKE - R.R.

See in Op. 1048A10

1. Remove the turbocharger flexible air intake pipe.

- Undo the clutch fluid reservoir plug and remove the protection.

- Remove the clutch fluid using a special syringe.

Op. 7055B54 UNDER-ENGINE GUARD - R R

- Have a suitable container ready.

1. Disconnect the rapid connector (1a) on the supply pipe (1b).

- Lower the vehicle.

- Get inside the vehicle on the driver''s side.

1. Release the fixing buttonsusing the special tool.

2. Remove the lower trim.

1. Undo the bolts fixing the pump master cylinder.

2. Expand the tabs in the slot and move the pump master cylinder push rod away from the pedal.

3. Disconnect the supply pipe rapid connector.

1. Disconnect the supply pipe rapid connector at the actuator cylinder.

- Release the supply pipe from the mountings and remove it.

Refitting

- Fit the supply pipe from the master cylinder to the pump and connect it to the actuator cylinder.

- Secure it to the retaining springs.

- Connect the supply pipe rapid connector to the pump master cylinder.

- Tighten the bolts fixing the pump master cylinder.

- Fit the lower dashboard trim, left hand side.

- Raise the vehicle.

- Connect the rigid fluid supply pipe rapid connector.

Op. 7055B54 UNDER-ENGINE GUARD - R R

- Fit the turbocharger flexible air intake hose.

See in Op. 1048A10

Op. 5010B18 CLIMATE CONTROL UNIT AIR INTAKE - R.R.

Op. 0010T67 HYDRAULIC CLUTCH SYSTEM BLEED AIR