Catalytic pre-converter - r r

Operation 1080B40 · Exhaust emission control system

1.9 JTD 8V · Euro 3

Removing

Place the car on the ramp.

Disconnect the battery negative terminal.

- 1048A23 cold air intake - r r

- 1072C44 exhaust manifold heat shield on bulkhead - r+r

1. Undo the nut fixing the coupling band to the turbocharger.

1.9 JTD 8V

Raise the lift.

1. Undo the bolts (1a) fixing the preconverter to the reinforcement bracket (1b).

2. Undo the fixing nuts (2a) on the exhaust pipe (2b).

3. Remove the catalytic preconverter from the engine compartment.

4. Keep the exhaust pipe gasket.

Refitting

Position the catalytic preconverter complete with gasket, then move the front section of the exhaust pipe closer and tighten the fixing nuts to torque.

Tighten the bolts fixing the catalytic preconverter to the reinforcement bracket to torque.

Lower the lift and tighten the nut on the band securing the converter to the turbocharger to torque.

- 1072C44 exhaust manifold heat shield on bulkhead - r+r

- 1048A23 cold air intake - r r

Connect the battery negative terminal.

Remove the car from the ramps.