Linkage supports and idlers - r+r

Operation 3380A40 · Handbrake control and linkage

Removing

Place the car on a lift.

Raise the ramp.

1. Undo the fixing nut (1a) and remove the support (1b) for the right rear drum flexible cable.

2. Remove the spring (2a) and, using the tool (2b), undo the connector (2c).

3. Undo the fixing bolt (3a), release the handbrake cable (3b) and remove the mounting bracket (3c).

4. Remove the plastic protection (4a) for the cable guide support, undo the fixing nuts (4b) and remove the cable mounting bracket (4c).

Refitting

Position the cable guide support, tighten the fixing nuts and fit the plastic protection.

Position the left rear drum cable mounting bracket and insert the handbrake cable in the special housing.

Tighten the bracket fixing bolts to torque.

Connect the two ends of the rear brake pipe and, using the tool, secure the connector nut.

Fit the right rear drum cable mounting bracket and position the cable in the special housing.

Tighten the fixing bolt to torque.

- 3330A18 front or rear hydraulic brake system - bleed