VALVE TAPPETS - Adjust. following clearance check

Operation 1036H18 · TAPPETS AND ROCKER SHAFTS

1.2 8v

1. Lower the tappet in question using a suitable tool.

2. Fit the tool for keeping the tappet lowered, then remove the pressure lever positioned previously.

1. Remove the valve clearanance adjustment plate and replace it with a one of a suitable thickness.

Remove the tool for keeping the tappet lowered.

Continue, repeating the procedure described for the remaining valves.

1.9 JTD 8V

1. Lower the tappet in question using the tool.

2. Maintain the tappet in lowered position with the tool, then withdarw the lever positioned previously.

1. Remove the valve clearanance adjustment plate and replace it with a one of a suitable thickness.

2. Remove the tool used to maintain the tappet in lowered position.

Proceed in the same way for the remaining valves.

1.4 8v

Op. 1048A10 AIR FILTER ASSEMBLY - R.R.

Op. 1056B82 INJECTION/IGNITION SYSTEM E.C.U. (ONE) - R + R

Op. 1056B87 IGNITION/INJECTION SYSTEM CONTROL UNIT SUPPORT - R.R.

Op. 5510C14 IGNITION COIL/S - R+R

Op. 1032D26 TIMING SYSTEM FRONT PROTECTIVE COVER (UPPER PART) - R.R.

Op. 1016A20 SINGLE TAPPET COVER -R.R AND REPLACE GASKET

Op. 1036H14 VALVE TAPPETS - CHECK CLEARANCE

- Lower the tappet in question using the tool.

- Fit the tool for keeping the tappet lowered, then withdraw the pressure lever.

- Remove the valve clearannce adjustment shim and replace it with a one of a suitable thickness.

- Remove the tool for keeping the tappet lowered.

- Proceed in the same way for the remaining valves.