Engine RPM sensor - r+r

Make

Fiat

Model

Doblò Factory Service Manual

Year

2000–2010

Section

Engine ignition › Engine RPM sensor - r+r

Electrical equipmentEngine RPM sensor - r+r

ENGINE RPM SENSOR - R+R

Operation 5510C26 · Coil, ecu, sensors

1.4 8v

Removing

For the 1.4 8v version only, if the rpm sensor is being replaced the following self-learning procedure must be carried out.

Start up the engine without pressing the accelerator pedal with an engine temperature greater than or equal to 20 °C and idle the engine for 10 seconds

- Disconnect the negative battery terminal.

1. Disconnect the electrical connection (1a), undo the bolt (1b) and remove the engine rpm sensor (1c).

	Description	Connector
1a	Rpm sensor	See K046 RPM SENSOR

Refitting

- Place the engine rpm sensor back in its housing, connect the electrical connection and tighten the bolt to the recommended torque.

	Value daNm	Fastening	Component	dia
	0.8 ÷ 1.0	Bolt	Rpm sensor	M6

- Connect the negative battery terminal.

16 Electrical