STARTER MOTOR - R+R

Operation 5520B10 · STARTER MOTOR AND COMPONENTS

2.0 JTS

Removing

Position the vehicle on a lift.

Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

Proceed with the removal

Op. 7055B54 UNDER-ENGINE GUARD - R R.

Proceed with the removal

Op. 1076B18 RIGID SECTION OF EXHAUST PIPE BETWEEN CATALYTIC CONVERTER AND SILENCER - R + R.

1. Undo the bolt (1a) and the nut (1b) and remove the exhaust pipe mounting (1c).

1. Disconnect the electrical connections from the starter motor.

2. Undo the bolts (2a) and remove the starter motor (2b).

Refitting

1. Place the starter motor (1a) in its housing and secure it tightening the bolts (1b) to the recommended torque.

2. Connect the electrical connections to the starter motor.

Place the exhaust pipe mounting back in its housing and secure it using the bolt and the nut.

Proceed with the refitting

Op. 1076B18 RIGID SECTION OF EXHAUST PIPE BETWEEN CATALYTIC CONVERTER AND SILENCER - R + R.

Proceed with the refitting

Op. 7055B54 UNDER-ENGINE GUARD - R R.

Connect the negative battery terminal (-).

Remove the vehicle from the lift.

1.9 JTD 16V

Removing

Position the vehicle on a lift.

Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

Proceed with the removal

Op. 7055B54 UNDER-ENGINE GUARD - R R.

Proceed with the removal

Op. 1076B70 EXHAUST PIPE BETWEEN PRE-CATALYTIC CONVERTER AND CATALYTIC CONVERTER - R R.

1. Disconnect the electrical connections from the starter motor.

1. Undo the bolts (1a) and remove the starter motor (1b).

Refitting

Place the starter motor in its housing and secure it tightening the bolts to the recommended torque.

Connect the electrical connections to the starter motor.

Proceed with the refitting

Op. 1076B70 EXHAUST PIPE BETWEEN PRE-CATALYTIC CONVERTER AND CATALYTIC CONVERTER - R R.

Proceed with the refitting

Op. 7055B54 UNDER-ENGINE GUARD - R R.

Connect the negative battery terminal (-).

Remove the vehicle from the lift.

1.8 T.SPARK

Removing

• Position the vehicle on a lift.
• Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

• Op. 1072C44 EXHAUST MANIFOLD HEAT SHIELD ON BULKHEAD - R+R
• Op. 1080B40 CATALYTIC PRE-CONVERTER - R R

1. Undo the nuts (1a) and disconnect the electrical connections (1b) from the starter motor.

2. Undo the bolts (2a) and remove the starter motor (2b).

Refitting

• Place the starter motor in its housing and secure it tightening the bolts to the recommended torque.

• Connect the electrical connections to the starter motor and secure them using the nuts.
• Op. 1080B40 CATALYTIC PRE-CONVERTER - R R
• Op. 1072C44 EXHAUST MANIFOLD HEAT SHIELD ON BULKHEAD - R+R
• Connect the negative battery terminal (-).
• Remove the vehicle from the lift.