Workshop Manuals Factory service & repair Alfa Romeo
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Transmission (4x4)12 Axles and driveshafts13 Brakes14 Steering15 Suspension and wheels16 Heating, air conditioning and auxiliary units17 Electrical equipment18 Body fittings19 Body panels and frame20 Wiring diagrams and electrical functions21 Wiring harnesses22 Connectors and pin-outs23 Fault diagnosis24 Special tools
Alfa Romeo 159 Factory Service Manual (2005-2011)23 · Fault diagnosis
23 · Diagnostics

Rear wheels lock whilst braking

Make
Alfa Romeo
Model
159 Factory Service Manual
Year
2005–2011
Section
Brakes › Rear wheels lock whilst braking
Fault diagnosisRear wheels lock whilst braking

REAR WHEELS LOCK WHILST BRAKING

When the brakes are operated the distribution between the front and rear wheels is not correct: in extreme conditions the rear wheels lock and the vehicle may skid

0PRELIMINARY CHECKSALL OKPROBLEMS ENCOUNTEREDACTION
First of all check whether the ABS warning light and the handbrake warning light come on simultaneously during starting and then go outMove on to Step 1The two warning lights remain on after starting

Proceed as instructed in the

See table K062 ABS AND HANDBRAKE WARNING LIGHTS BOTH ON

1CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION

Connect the diagnostic test equipment (Examiner or other instruments) to the tester input.

Check that there are no faults in the ABS control unit.

Move on to Step 21. Error detected in the control unit.1. Continue following the instructions for the diagnostic equipment
2. No communication with the control unit.

2. Restore:

  • Connection between the ABS control unit and the diagnostic connector;
  • ABS control unit supply

See E7020 ABS

2ACTIVE DIAGNOSIS WITH DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION

Connect the diagnostic equipment (Examiner or other instruments) and carry out the active diagnosis for:

  • Pump motor;
  • Solenoid valves.
Move on to Step 3Fault detected in one of the solenoid valves.

Replace the ABS electronic control unit electrohydraulic unit

Op. 3340A12 ABS HYDRAULIC AND ELECTRONIC CONTROL UNIT - R.R.

3REAR BRAKE CALIPER CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check the condition of the rear brake caliper pistons.Move on to Step 4Pistons worn or seized.

Replace the rear brake calipers

Op. 3310B34

4CHECK ON FLEXIBLE BRAKE PIPES AND BLEEDINGALL OKPROBLEMS ENCOUNTEREDACTION

Visually inspect that there are no bends or constrictions in the brake pipes, bleed the system and check that the fluid comes out evenly from the bleed screws.

Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR

Move on to Step 5Bends or constrictions present, the fluid does not come out evenly.

Replace the section of pipe affected by the problem

Op. 3340B ABS SYSTEM PIPES

5FRONT BRAKE STATE CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Visually inspect that there is no grease, oil or dirt on the braking surfaces of the front pads.End of diagnosisBraking surfaces dirty.

Clean, check and eliminate the causes of the problem: if necessary, replace the front pads

Op. 3310A60 FRONT BRAKE PADS - REPLACE

Parts & tools for this job Staging For 2005 Alfa Romeo 159

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.