Workshop Manuals Factory service & repair Alfa Romeo
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Transmission (4x4)12 Axles and driveshafts13 Brakes14 Steering15 Suspension and wheels16 Heating, air conditioning and auxiliary units17 Electrical equipment18 Body fittings19 Body panels and frame20 Wiring diagrams and electrical functions21 Wiring harnesses22 Connectors and pin-outs23 Fault diagnosis24 Special tools
Alfa Romeo 159 Factory Service Manual (2005-2011)08 · Engine
08 · Engine

Upstream lambda sensor operation check

Make
Alfa Romeo
Model
159 Factory Service Manual
Year
2005–2011
Section
Emission control system › Upstream lambda sensor operation check
EngineUpstream lambda sensor operation check

UPSTREAM LAMBDA SENSOR OPERATION CHECK

Check 1080BA

1.8, 1.9 JTS, 2.2 JTS, 3.2 JTS

CHECK TO BE PERFORMEDRESOLUTION IF THE CHECK IS NOT OK
1

Select the following parameters on the diagnostic equipment:

- voltage of Lambda sensor upstream of the catalytic converter

- voltage of Lambda sensor upstream of the catalytic converter 2

- Lambda control factor

- Lambda 2 control factor

2

With the engine started, press the accelerator pedal several times, more or less rapidly, and check that the values of the parameters selected vary as a result at a corresponding speed.

The test can be considered over

Move on to Step 3
3If there is no variation in one or both the Lambda sensors when the accelerator pedal is pressed, check that there are no errors linked to the Lambda sensors in the control unitContinue as described by the diagnostic equipment
4

If there is a slow response by one or both of the Lambda sensors to the accelerator pedal being pressed, remove the faulty sensors and check that there are no signs of fouling.

The test can be considered over

Move on to Step 5
5

Clean the faulty sensor again with a dry cloth.

Do not use petrol, water or special products to clean the sensor because they could damage it.

If the sensor was fouled by fuel, move on to Step

If the sensor was fouled by oil, move on to Step 8
6Check that the errors memory does not indicate that there was misfire previouslyContinue as described by the diagnostic equipment
7

Check that there are no fuel leaks from the injectors, by carrying out the

See Test 1056BA INJECTOR OPERATION CHECK

The test can be considered over
8

Check that there are no engine oil leaks, as instructed in the

See table X12 ENGINE OIL LEAKS

Parts & tools for this job Staging For 2005 Alfa Romeo 159

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.