Workshop Manuals Factory service & repair Lancia
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Lancia Ypsilon Factory Service Manual (2003-2011)01 · General information
01 · General

Towing points

Make
Lancia
Model
Ypsilon Factory Service Manual
Year
2003–2011
Section
Vehicle towing and lifting points › Towing points
General informationTowing points

TOWING POINTS

The vehicle has two threaded sockets, one at the front and one at the rear, for fitting the tow hook which is housed in the compartment in the spare wheel in the luggage compartment under the carpet.

TOWING POINTS

When towing the vehicle, the laws governing towing and road traffic must be obeyed.

Before towing, make sure that the tow hook is fully tightened.

Thoroughly clean the threaded housing before tightening the tow hook.

Turn the ignition key to the ON position and then to the OFF position and DO NOT EXTRACT IT !

When the key is extracted, the steering lock is immediately engaged and it is consequently impossible to steer the wheels.

Whilst towing, as the brake servo is not working, greater force will have to be exerted on the brake pedal.

The towing vehicle should be driven as smoothly as possible to prevent the two vehicles striking one another.

Do not use flexible cables for towing and avoid jerking.

During towing operations, check that the tow cable coupling does not damage parts with which it comes into contact.

For versions with automatic transmission, observe the following additional instructions:

  • 1) place the gear lever in N (checking that the vehicle moves when pushed);
  • 2) maintain a towing speed less than 30 km/h;
  • 3) the maximum towing distance is 20 km For greater distances, raise the front end of the car to prevent damage to the transmission due to insufficient lubrication.

After having raised the vehicle, support it using safety stands.

Before lifting the front of the vehicle, lock the wheels using chocks in behind the rear wheels.

When lifting the front of the vehicle, this may be done only by positioning the lift arm beneath the gearbox-differential unit and placing a wooden or rubber block between the arm and the vehicle.

Parts & tools for this job Staging For 2003 Lancia Ypsilon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.