Trip meter does not zero
- Make
- Lancia
- Model
- Ypsilon Factory Service Manual
- Year
- 2003–2011
- Section
- Instrument panel › Trip meter does not zero
Fault diagnosisTrip meter does not zero
TRIP METER DOES NOT ZERO
With the ignition ON, the milometer cannot be zeroed using the TRIP button on the right steering column switch unit lever.
| Results of the tests | ||||
| 1 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|---|---|---|---|
Connect the Examiner to the diagnostic socket Check that there are no faults in the instrument panel | Continue to Step 2 | There are errors | Proceed in accordance with the instructions given by the diagnostic equipment | |
| 2 | ELECTRICAL CIRCUIT CHECK | All OK | Problems met | Operation |
Check:
| Continue to Step 3 | Connections defective, earth or supply defective | Restore the correct connections, if necessary, replace the wiring: See E4010 INSTRUMENT PANEL | |
| 3 | CHECK ON STEERING COLUMN SWITCH UNIT | All OK | Problems met | Operation |
| Check that the TRIP button on the right steering column switch unit lever is working properly See E4010 INSTRUMENT PANEL | Continue to Step 4 | Right lever defective | Replace the steering column switch unit Op. 5550A12 | |
| 4 | CHECK ON CORRECT OPERATION | All OK | Problems met | Operation |
| Check that the fault is no longer present | End of diagnosis | |||
Parts & tools for this job Staging For 2003 Lancia Ypsilon
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Lancia Ypsilon
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.