Workshop Manuals Factory service & repair Lancia
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Lancia Ypsilon Factory Service Manual (2003-2011)22 · Fault diagnosis
22 · Diagnostics

Milometer not working

Make
Lancia
Model
Ypsilon Factory Service Manual
Year
2003–2011
Section
Instrument panel › Milometer not working
Fault diagnosisMilometer not working

MILOMETER NOT WORKING

The milometer either does not work or does not work properly whilst driving.

The speedometer works properly. If the speedometer is faulty, see Table K003.

Results of the tests
0PRELIMINARY CHECKAll OKProblems metOperation

Check:

  • that the instrument panel light dimmer has not been selected.
  • That the mode button has not been pressed.
  • That there are no failure messages displayed
Continue to Step 1The display shows other informationRestore the display conditions using the control panel
1CHECK WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation

Connect the Examiner to the diagnostic socket

Check that there are no faults in the instrument panel

Continue to Step 2There are errorsProceed in accordance with the instructions given by the diagnostic equipment
2CHECK WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation
Keeping the Examiner connected to the diagnostic socket, check the operation of the display in active diagnosis.Continue to Step 3Milometer not workingReplace instrument panel Op. 5560B11
3ELECTRICAL CIRCUIT CHECKAll OKProblems metOperation
Check connections between instrument panel Body Computer and ABS control unitContinue to Step 4Faulty wiringRestore/replace the wiring: See E4010 INSTRUMENT PANEL
4CHECK WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation

With the diagnostic equipment (Examiner or other instruments) connected, check the CAN information:

  • For inactive control units;
  • That there are no control unit errors;
  • That there are no control units with CAN line errors
Continue to Step 5Presence of faultsContinue following the instructions for the diagnostic equipment
5CHECK ON CORRECT OPERATIONAll OKProblems metOperation
Check that the fault is no longer presentEnd of diagnosis

Parts & tools for this job Staging For 2003 Lancia Ypsilon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.