22 · Diagnostics

I.e. failure warning light flashing

Fault diagnosisI.e. failure warning light flashing

I.E. FAILURE WARNING LIGHT FLASHING

1.2 8v, 1.2 16v, 1.4 16v

The MIL failure warning light flashes when the engine has been started

The warning light can flash in two different ways: with the vehicle started up and stationary or with the vehicle driving.

1	CHECK ON FUEL RESERVE WARNING LIGHT	All OK	Problems met	Operation
		Results of the tests
	Check that the fuel reserve warning light is off	Continue to Step 2	Fuel reserve warning light on	Make sure the fuel level is above the reserve area Continue to Step 4
2	FUEL LEVEL CHECK	All OK	Problems met	Operation
	Check that the fuel gauge is working properly	Continue to Step 3	Fuel gauge not working	See table K20
3	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the diagnostic equipment (Examiner or Examiner Plus) and check: that there is no 'Misfire' error	End of diagnosis	'Misfire' error present	See table Z53
4	ERROR CANCELLING AND CHECKING	All OK	Problems met	Operation
	Use a tester to cancel the errors in the control unit. Road test the vehicle and check that the error does not occur again	Continue to Step 5	'Misfire' error present	See table Z53
5	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.