Throttle case - r + r

Operation 1056B14 · Multi-point injection system (mpi)

1.2 8v

Removing

Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).

Proceed with removal - 1048A10 air cleaner filtering element - replace.

1. Disconnect the accelerator cable (1a) from the throttle valve drive (1b), release from the mounting bracket (1c) and move aside.

1. Undo the bolts (1a) and move the injection/ignition control unit control unit (1b) aside.

2. Disconnect the electrical connection from the throttle valve position sensor.

3. Disconnect the engine idle actuator electrical connection.

4. Undo the nut (4a) and disconnect the earth lead (4b) from the injection/ignition control unit.

5. Undo the fixing bolts (5a) and remove the throttle body (5b).

Refitting

Place the throttle body back in its housing and secure it tightening the bolts to the recommended torque.

Connect the earth lead to the injection / ignition control unit and secure it with its bolt.

Connect the engine idle actuator electrical connection.

Connect the electrical connection to the throttle valve position sensor.

Refit the fuel injection/ignition control unit in its seating and secure it with its bolts.

Refit the throttle cable and secure to the bracket.

Connect the accelerator cable to the throttle valve.

Proceed with refitting - 1068A10 accelerator pedal control - check, adjust if necessary and lubricate.

Proceed with refitting - 1048A10 air cleaner filtering element - replace.

Connect the negative (-) battery terminal.