Engine coolant temperature sensor - r r

Operation 1060G14 · Pressure pump electric control

1.3 JTD

Removing

Position the vehicle on the ramp.

Proceed with removal.

1. Loosen the band and disconnect the lower radiator coolant outlet hose from the radiator, radiator side.

Collect the engine coolant in a suitable container.

Proceed with removal - 5530B10 battery - r+r.

Proceed with removal - 5530B52 Battery DRIP TRAY/SUPPORT - R.R..

1. Undo the bolts fixing the rigid engine oil vapour recirculation pipe.

2. Loosen the band and disconnect the engine oil vapour recirculation pipe from the rigid pipe.

1. Disconnect the electrical connection from the engine coolant temperature sensor.

2. Undo and remove the engine coolant temperature sensor.

Refitting

Place the engine coolant temperature sensor back in its housing and tighten it to the recommended torque.

Restore the sealant on the sensor thread.

Connect the electrical connection to the engine coolant temperature sensor.

Connect the engine oil vapour recirculation hose to the rigid pipe and tighten the band.

Tighten the bolts securing the engine oil vapour recirculation rigid pipe.

Proceed with refitting - 5530B52 Battery DRIP TRAY/SUPPORT - R.R..

Proceed with refitting - 5530B10 battery - r+r.

Connect the lower coolant outlet hose from the radiator, radiator side, and tighten the band.

Refill the engine cooling system with coolant - 0010T20 coolant change.

Proceed with refitting.

Remove the car from the ramps.