General acceleration and slewing SENSOR

Make

Lancia

Model

Thesis Factory Service Manual

Year

2002–2009

Section

Traction control › General acceleration and slewing SENSOR

BrakesGeneral acceleration and slewing SENSOR

General acceleration and slewing SENSOR

Operation 3350E30 · VEHICLE DIRECTION CONTROL SYSTEM V.D.C.

Removing

- Disconnect the negative battery terminal.

See in Op. 5040D19 CONTROL UNIT with CONTROL PANEL for rear air conditioning - R.R.

See in Op. 7040L70 Tunnel cover REAR COVER - R.R.

See in Op. 5010C32 Air VENT in tunnel cover for rear seats

See in Op. 7040A65 passenger compartment box lock, one, r r

See in Op. 7045A10 FRONT SEAT (one) left or right - R.R.

See in Op. 7040L37 GEAR LEVER SURROUNDING TRIM - R.R.

See in Op. 7040L20 TUNNEL COVER - R.R.

1. Undo the fixing nuts.

2. Disconnect the electrical connector (2a) and remove the general acceleration and slewing sensor (2b).

Refitting

- Connect the electrical connector and position the general acceleration and slewing sensor.

- Tighten the fixing nuts.

See in Op. 7040L20 TUNNEL COVER - R.R.

See in Op. 7040L37 GEAR LEVER SURROUNDING TRIM - R.R.

See in Op. 7045A10 FRONT SEAT (one) left or right - R.R.

See in Op. 7040A65 passenger compartment box lock, one, r r

See in Op. 5010C32 Air VENT in tunnel cover for rear seats

See in Op. 7040L70 Tunnel cover REAR COVER - R.R.

See in Op. 5040D19 CONTROL UNIT with CONTROL PANEL for rear air conditioning - R.R.

- Connect the negative battery terminal.

12 Brakes