22 · Diagnostics

Code failure warning light on

Make: Fiat
Model: Multipla Factory Service Manual
Year: 1998–2010
Section: Instrument panel › Code failure warning light on

‹ Prev I.e. failure warning light on Next › I.e. failure warning light off / (do not carry out initial test)

Fault diagnosisCode failure warning light on

CODE FAILURE WARNING LIGHT ON

During starting, the CODE warning light.comes on and remains on for more than 0.7 seconds. (after carrying out the initial control unit test, the warning light should go out, ...)

0	PRELIMINARY CHECKS	All OK	Problems met	Operation
		Results of the tests
	Check that the CODE aerial is correctly positioned in the ignition switch	Continue to Step 1	CODE aerial not correctly connected	Restore the correction or replace the aerial Op. 5580E08
1	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the diagnostic equipment (Examiner or other instruments) to the diagnostic socket Check: that there are no faults in the CODE control unit	Continue to Step 2	An error is detected in the control unit	Continue according to the instructions for the diagnostic equipment
		Continue to Step 2	Lack of dialogue with the control unit	Restore the connection between the CODE control unit and the diagnostic connector ( See E7010 CODE).
2	CHECKING CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	Fault persists	Search for the fault starting from another symptom'

‹ Prev I.e. failure warning light on Next › I.e. failure warning light off / (do not carry out initial test)

Parts & tools for this job Staging For 1998 Fiat Multipla

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.