Under-engine guard - r r
- Make
- Fiat
- Model
- Multipla Factory Service Manual
- Year
- 1998–2010
- Section
- Mouldings on protections › Under-engine guard - r r
‹ Prev REAR WHEEL ARCH liner (one), left or right - R.R.Next › Engine compartment dust shield protection in right front wheel arch - r.r.
Body fittingsUnder-engine guard - r r
Under-engine guard - r r
Removing
Place the vehicle on a lift.
Raise the car.
1. Undo the bolts fixing the protective shield under the engine.
2. Remove the protective shield under the engine.
Refitting
Check that the protective shield under the engine is not damaged.
1. Position the protective shield under the engine and tighten the rear bolts.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| Bolt | UNDE-ENGINE PROTECTION/GUARD | M8 | 2.7 |
2. Tighten the front bolts.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| Bolt | UNDE-ENGINE PROTECTION/GUARD | M6 | 8.5 |
3. Tighten the side bolts.
Remove the vehicle from the lift.
‹ Prev REAR WHEEL ARCH liner (one), left or right - R.R.Next › Engine compartment dust shield protection in right front wheel arch - r.r.
Parts & tools for this job Staging For 1998 Fiat Multipla
- PARTEngine gasket setSearch: Fiat Multipla 1998 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.