SPLIT REAR SEAT ASSEMBLY - R+R

Operation 7050A14 · REAR SEAT ASSEMBLY

Removing

Op. 7050A22 REAR SEAT CUSHION - R+R

(right and left)

Op. 7040H80 PARCEL RACK

Op. 7040B10 LOAD PLATFORM (LUGGAGE PLATFORM) TRIM - R+R

1. Undo the front bolts fixing the backrest to the floor.

Use a HEXAGONAL SPLINED wrench No. 8 (USAG 234 or equivalent).

2. Undo the bolt fixing the end of the middle rer seat belt.

Lower the squab.

1. Undo the middle nuts (1a) and bolts (1b) fixing the backrest to the floor.

2. Undo the left side nut (2a) and bolt (2b) fixing the backrest to the floor.

Use a HEXAGONAL SPLINED wrench No. 8 (USAG 234 or equivalent).

1. Undo the right side nut (1a) and bolt (1b) fixing the backrest to the floor.

2. Remove the squabs.

Refitting

Check that the squabs are not damaged.

Position the squabs.

Tighten the middle and side nuts and bolts fixing the backrests to the floor.

Use the bolts specified by the manufacturer because longer bolts could interfere with the fuel tank.

Tighten the middle and side bolts fixing the backrests to the floor.

Lift the squab.

Tighten the front bolts fixing the backrests to the vehicle floor.

Use the bolts specified by the manufacturer because longer bolts could interfere with the fuel tank.

If necessary, adjust the striker.

Op. 7050A45 STRIKER OF ONE SPLIT REAR SEAT SQUAB FASTENING RELEASE DEVICE ONE LH OR RH R R

Position the end of the middle rear seat belt and fasten it using the bolt.

Op. 7050A22 REAR SEAT CUSHION - R+R

(right and left).

Op. 7040B10 LOAD PLATFORM (LUGGAGE PLATFORM) TRIM - R+R.

Op. 7040H80 PARCEL RACK.