BONNET LID - SQUARE

Operation 7025A10 · LOCATION OF BONNET WIND NOISE

Lift the bonnet lid.

1. If necessary, adjust the buffer blocks.

2. If necessary, adjust the lock position.

Op. 7025A34 BONNET LID LOCK (ONE) - R+R OR REPAIR.

1. If necessary, undo the hinge bolts and adjust the bonnet position. The arrows indicate possible movements.

Tighten the hinge bolts.

If the adjustments described above are insufficient, adjust bonnet lid hinge position as described below.

Op. 7055B64 LH OR RH REFLECTOR(ONE) ON REAR BUMPERS - R R

(right and left).

Op. 7055B42 LH OR RH REFLECTOR(ONE) ON REAR BUMPERS - R R

(right and left).

1. Remove the soundproofing.

2. Slacken the nuts (2a) securing the hinges (2b) and adjust the position until the bonnet is aligned. The arrows (2c) indicate the possible movements.

3. Tighten the nuts.

Touch up the paintwork in the hinge area.

Fit the soundproofing in position.

Op. 7055B42 LH OR RH REFLECTOR(ONE) ON REAR BUMPERS - R R

(right and left).

Op. 7055B64 LH OR RH REFLECTOR(ONE) ON REAR BUMPERS - R R

(right and left).