Workshop Manuals Factory service & repair Alfa Romeo
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Transmission (4x4)12 Axles and driveshafts13 Brakes14 Steering15 Suspension and wheels16 Heating, air conditioning and auxiliary units17 Electrical equipment18 Body fittings19 Body panels and frame20 Wiring diagrams and electrical functions21 Wiring harnesses22 Connectors and pin-outs23 Fault diagnosis24 Special tools
Alfa Romeo Brera and Spider Factory Service Manual (2005-2010)08 · Engine
08 · Engine

Diesel fuel pressure check

Make
Alfa Romeo
Model
Brera and Spider Factory Service Manual
Year
2005–2010
Section
Diesel injection system › Diesel fuel pressure check
EngineDiesel fuel pressure check

DIESEL FUEL PRESSURE CHECK

Check 1060GH

2.4 JTD 20v

CHECK TO BE PERFORMEDRESOLUTION IF THE CHECK IS NOT OK
1With the engine idling and warm, with all users off and the accelerator pedal not operated, the target Diesel Pressure and the measured Diesel Pressure must be in a range between 200 and 500 barsMove on to Step 3
2

When the accelerator pedal is pumped several times, the measured Diesel Pressure must be in a range between 200 and 1500 bars.

The test can be considered over

Move on to Step 3
3

Turn the ignition key to the OFF position.

Disconnect the wiring harness connector from the fuel pressure sensor.

See K083 FUEL PRESSURE SENSOR

Turn the ignition key ON. Measure the voltage between Pin 3 of the sensor and Earth, checking that it is within a range between 4.8 and 5.2 V.

See K083 FUEL PRESSURE SENSOR

Move on to Step 5

Move on to Step 4
4

If faults are present, repair or if necessary replace the electrical wiring between the engine control unit and the debimeter.

See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT

The test can be considered over

Replace the engine management control unit

Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - .R

5

Measure the voltage between Pins 1 and 3 of the sensor. Check it is in a range between 4.8 and 5.2 V

See K083 FUEL PRESSURE SENSOR

Move on to Step 4
6

Measure the voltage between Pin 2 of the sensor and Earth, ensuring it is in a range between 4.8 and 5.2 V.

See K083 FUEL PRESSURE SENSOR

Move on to Step 4
7

Replace the pressure sensor and check the fault has disappeared

Op. 1060G28 FUEL PRESSURE SENSOR ON FUEL MANIFOLD TO INJECTORS - R.R

Repair the original pressure sensor and replace the engine management control unit.

Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - .R

Parts & tools for this job Staging For 2005 Alfa Romeo Brera

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.