SWITCH on CLUTCH PEDAL - R.R.

Operation 1056B78 · Multi-point injection system (mpi)

1.2 8v

Removing

Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).

1. Disconnect the electrical connection from the switch on the clutch pedal.

2. Rotate and remove the switch on the clutch pedal.

1.2 16v

Removing

Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).

1. Disconnect the electrical connection from the switch on the clutch pedal.

2. Rotate and remove the switch on the clutch pedal.

1.4 16v

Removing

Ensure that the ignition key is in OFF position, then disconnect the battery negative terminal (-).

1. Disconnect the electrical connection from the switch on the clutch pedal.

2. Rotate and remove the switch on the clutch pedal.

1.2 8v

Refitting

Press the clutch pedal, then refit the clutch pedal switch and turn clockwise/anticlockwise until the retainer tooth can be heard clicking into the seat on the bracket.

Release the cltuch pedal and pull back until it is fully released.

This must be done because if the switch is not fully back, it could hold the clutch pedal forward and prevent the cltuch and flywheel from coupling properly.

Check there is clearance between the end of the switch and the contact plate on the clutch pedal.

Connect the electrical connection to the switch on the clutch pedal.

Connect the negative (-) battery terminal.

1.2 16v

Refitting

Press the clutch pedal, then refit the clutch pedal switch and turn clockwise/anticlockwise until the retainer tooth can be heard clicking into the seat on the bracket.

Release the cltuch pedal and pull back until it is fully released.

This must be done because if the switch is not fully back, it could hold the clutch pedal forward and prevent the cltuch and flywheel from coupling properly.

Check there is clearance between the end of the switch and the contact plate on the clutch pedal.

Connect the electrical connection to the switch on the clutch pedal.

Connect the negative (-) battery terminal.

1.4 16v

Refitting

Press the clutch pedal, then refit the clutch pedal switch and turn clockwise/anticlockwise until the retainer tooth can be heard clicking into the seat on the bracket.

Release the cltuch pedal and pull back until it is fully released.

This must be done because if the switch is not fully back, it could hold the clutch pedal forward and prevent the cltuch and flywheel from coupling properly.

Check there is clearance between the end of the switch and the contact plate on the clutch pedal.

Connect the electrical connection to the switch on the clutch pedal.

Connect the negative (-) battery terminal.