Workshop Manuals Factory service & repair Lancia
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Lancia Ypsilon Factory Service Manual (2003-2011)09 · Clutch
09 · Transmission

(Pump) - MASTER CYLINDER R.R.

Make
Lancia
Model
Ypsilon Factory Service Manual
Year
2003–2011
Section
Clutch release controls › (Pump) - MASTER CYLINDER R.R.
Clutch(Pump) - MASTER CYLINDER R.R.

(Pump) - MASTER CYLINDER R.R.

Operation 1820B20 · HYDRAULIC CLUTCH SYSTEM

Removing

Position the vehicle on the ramp.

Proceed with removal - 4450B02 left front wheel r r.

Proceed with removal - 7055B90 Left front WHEEL ARCH LINER - R.R..

1. Working from the passenger compartment, place the clutch pedal in the end of travel position then release the retainers securing the locking device to the pedal.

2. Release the master cylinder push rod from the locking device.

(Pump) - MASTER CYLINDER R.R.

1. Release the pipe between the master cylinder and the clutch operating cylinder (1a) from the bands (1b) on the flexible mounting for the power unit gearbox side rigid support.

2. Lift up the retaining clip (2a) and disconnect the pipe between the master cylinder and the operating cylinder (2b), master cylinder side.

Collect the brake-clutch fluid which comes out in a suitable container.

3. Loosen the band and disconnect the flexible pipe from the clutch reservoir to the master cylinder, master cylinder side.

4. Undo the bolts (4a) and remove the master cylinder (4b).

(Pump) - MASTER CYLINDER R.R.

Refitting

Place the clutch master cylinder back in its housing and fix it tightening the bolts to the recommended torque.

FasteningComponentØ

Value

(daNm)

BoltCLUTCH FLUID MASTER CYLINDERM6(Bodyshell side) 0.6 ÷ 1.0

Connect the flexible pipe from the clutch reservoir to the master cylinder, master cylinder side and tighten the clutch.

Fit the pipe between the master cylinder and the operating cylinder fully home in its seat on the clutch master cylinder and secure with the retaining clip.

Fasten the pipe between the master cylinder and the clutch operating cylinder on the power unit gearbox side rigid support flexible mounting using the bands.

Connect the master cylinder push rod to the locking device.

Connect the clutch pedal to the locking device using the clips.

Proceed with refitting - 0010T64 brake and or clutch fluid check level and top up as necessary.

Proceed with refitting - 0010T67 hydraulic clutch system bleed air.

Proceed with refitting - 7055B90 Left front WHEEL ARCH LINER - R.R..

Proceed with refitting - 4450B02 left front wheel r r.

Remove the car from the ramps.

Parts & tools for this job Staging For 2003 Lancia Ypsilon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.