Protective moulding on rear bumper - r r
- Make
- Lancia
- Model
- Ypsilon Factory Service Manual
- Year
- 2003–2011
- Section
- Moulding and protection › Protective moulding on rear bumper - r r
‹ Prev Protective moulding on rear bumper (1), lh or rh - r rNext › Left hand rear supplementary wheel arch - r+r
Body fittingsProtective moulding on rear bumper - r r
Protective moulding on rear bumper - r r
Removing
1. Position adhesive tape (1a) along the entire perimeter of the moulding (1b).
2. Move the moulding (1b) releasing the retainers (2a).
3. Disconnect the electrical connection for the parking sensors.
4. Recover the trim.
Refitting
Check that the moulding is undamaged.
Connect the electrical connections for the parking sensors.
Place the moulding in position attaching the retainers.
Remove the protective adhesive tape.
‹ Prev Protective moulding on rear bumper (1), lh or rh - r rNext › Left hand rear supplementary wheel arch - r+r
Parts & tools for this job Staging For 2003 Lancia Ypsilon
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Lancia touch up paint
- PARTPanel clip assortmentSearch: Lancia panel clips assortment
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.