Sun-roof control switch - r+r

Operation 7030B64 · Sliding roof

Removing

Disconnect the battery negative terminal.

1. Release the switch holder trim from the housing in the roof lining.

2. Disconnect the sun roof control switch electrical connection.

3. Remove the switch (3a) from the trim (3b).

Refitting

Fit the sun roof control switch in the trim.

Place the switch holder trim in position.

Connect the sun roof control switch electrical connection.

Place the switch holder trim in position.

Connect the battery negative terminal.

After the battery has been disconnected or a fuse has blown, the system must be initialized again, proceeding as follows:

• press the switch in the 'roof closed' position;
• keep the switch pressed: the roof will close in stages;
• keeping the switch pressed, wait for the roof to close fully until the motor is stopped;
• release the switch.