Workshop Manuals Factory service & repair Alfa Romeo
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Transmission (4x4)12 Axles and driveshafts13 Brakes14 Steering15 Suspension and wheels16 Heating, air conditioning and auxiliary units17 Electrical equipment18 Body fittings19 Body panels and frame20 Wiring diagrams and electrical functions21 Wiring harnesses22 Connectors and pin-outs23 Fault diagnosis24 Special tools
Alfa Romeo Brera and Spider Factory Service Manual (2005-2010)23 · Fault diagnosis
23 · Diagnostics

Engine coolant consumption

Make
Alfa Romeo
Model
Brera and Spider Factory Service Manual
Year
2005–2010
Section
Consumption /leaks/ wear › Engine coolant consumption
Fault diagnosisEngine coolant consumption

ENGINE COOLANT CONSUMPTION

2.2 JTS, 3.2 JTS

Coolant consumption is high (frequent topping up is required)

0PRELIMINARY CHECKSAll OKProblems encounteredOperation
Bleed the air and check the fault does not recur.End of diagnosisThe fault recursMove on to Step 1
1CHECK ON THE EFFICIENCY OF THE EXPANSION TANK CAPAll OKProblems encounteredOperation
Check the efficiency of the expansion tank cap.Move on to Step 2Cap inefficient.Replace the cap.
2COOLING SYSTEM LEAKAGE TESTAll OKProblems encounteredOperation

Check the seal of the cooling system

Op. 0510C30 ENGINE COOLING SYSTEM - LEAKAGE TEST

Move on to Step 3There are engine cooling system leaks.

Proceed as instructed in the

See table X10 ENGINE COOLANT LEAKS

3CHECK FOR GURGLINGAll OKProblems encounteredOperation
Check that no gurgling or oil is present in the coolant reservoir.Move on to Step 4Presence of fluid or air bubbles: head gasket damaged.Replace the damaged gasket.
4CHECK CYILNDER HEAD HYDRAULIC SEALAll OKProblems encounteredOperation
Check the hydraulic seal of the cylinder head.Move on to Step 5Seal not efficient.

(only for 3.2 V6 version)

Remove the cylinder head

Op. 1016C10 SINGLE CYLINDER HEAD - R.R. AND REPLACE GASKET

(only for 3.2 V6 version) Replace the head

Op. 1016D10 CYLINDER HEAD – R.R. AND REPLACE GASKETS

5CHECK ENGINE MONOBLOC HYDRAULIC SEALAll OKProblems encounteredOperation
Check the hydraulic seal of the monoblocMove on to Step 6Seal not efficient.Replace the monobloc
6CHECK ON CORRECT OPERATIONAll OKProblems encounteredOperation
Check that the fault is no longer present.End of diagnosisThe fault persists.Contact Technical Service for further information on the problem.

Parts & tools for this job Staging For 2005 Alfa Romeo Brera

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.