Data
- Make
- Peugeot
- Model
- J5 Factory Workshop Manual
- Year
- 1982–1994
- Section
- Rear suspension – identification - data › Data
SuspensionData · page 1 of 2
DATA
The rear suspension unit is connected to the body by :
Two longitudinal leaf springs.
Each spring consists of two main leaves and two delayed action leaves.
The spring is secured to the axle by two clamps.
The spring is secured to the body :
- at the front : by a pin and a moving support.
- at the rear : by a shackle with pins welded to it and by a moving support.
The front bush in the spring and the pins on the rear shackle are covered with a rubber coating that carries out the same functions as a rubber bush.
Suspension travel limiting systems :
- in compression : two rubber stops on either side.
- out stop : an integral stop inside the damper.
Two double acting telescopic dampers.
| Vehicle | Th : Leaf springs Fig. I | Dampers Ref : C | |||||
|---|---|---|---|---|---|---|---|
| 1 | 2 | space | 3 | 4 | Total | ||
| Van 1000 Van, ambulance conversion Combi 1000 | 8 | 8 | a : 14 | 8 | 8 | 32 | 5965 476 Fig. I - III |
| Van 1300 to 1500 | 8 | 8 | b : 4 | 13 | 13 | 46 | 4439 194 Fig. I - III |
| Platform cab 1300 to 1500 | 8 | 8 | b : 4 | 13 | 13 | 46 ref. white | 7534 624 Fig. I - III |
| Chassis cab 1300 to 1500 Bare chassis 1300 to 1500 | 7576 729 Fig. II - IV | ||||||
| Van 1800 | 9 | 9 | b : 4 | 12.5 | 12.5 | 47 | 7562 124 Fig. I - III |
| Chassis cab 1800 | 7543 566 Fig. II - IV | ||||||
Parts & tools for this job Staging For 1982 Peugeot J5
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTRear shock absorbersSearch: Peugeot J5 1982 rear shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.