Running gearNominal values front axle
| Nominal values front axle |
| t
| Technical data apply for the unladen weight of the vehicle ready for driving (full fuel tank and water reservoir for the windscreen wiper washer system, spare wheel and jack (if the vehicle was fitted at the factory with them), tool kit and without driver) (unladen weight). |
| t
| Explanations concerning chassis PR Numbers → Chapter |
Note | –
| Load the vehicle with a corresponding weight. |
| –
| Determine the fuel volume in the fuel tank on the fuel gauge. |
| –
| Place a weight above the fuel tank according to the following table: |
|
|
|
| Fuel gauge | Weight (kg) |
| Reserve | 38 |
| 1/4 | 33 |
| 1/2 | 22 |
| 3/4 | 11 |
| Tank full | 0 |
Note | t
| Use as weight e.g. plastic tanks filled with water or canisters. 1 liter of water = 1 kg. |
| t
| When fitting the weight onto the rear seat pay special attention so that the seat upholsteries are not dirty or damaged. |
|
|
|
| Front axle - chassis | Standard suspension | Rough road suspension |
| PR numbers | G40, G41 | G38, G39 |
| Overall track -adjustable- | 10' ±10' | 10' ±10' |
| Toe difference angle on turns of 20° of inside wheel -not adjustable- | 1° 30' ±20' | 1° 30' ±20' |
| Max. wheel lock angle -not adjustable- | 39° 14' | 39° 14' |
| Camber1) | -28' ±30' | -18' ±30' |
| Max. difference between left and right side | max. 30 | max. 30 |
| Castor | 4° 21' ±30' | 4° 21' ±30' |
| Max. difference between left and right side | max. 30 | max. 30 |
| The given geometry values are valid for all types of engines. |
| 1) It is possible to adjust the camber by shifting the assembly carrier. Note: Always replace the screws! After carrying out corrections of steering geometry, inspect position of steering wheel and alter to correct position, if necessary. |
01 Steering & suspension
