Refitting

– Remove : fig. I and II.

• the bolts (1) that secure the front plate (2),
• the bolts (3) that secure the rear plate (4).

– Lower the axle tube by a few centimetres.

– Remove the spring, by releasing the spring centre pin from its location on the axle tube.

– Remove : fig. III and IV.

• the nut, front securing pin (5) and the plate (2).
• the nuts (6), plate (7), shackle (8) and the rear securing plate (4).

REFITTING

– Fit : fig. III and IV

• the rear plate (4), the shackle (8), plate (7) and nuts (6), without tightening them,
• front plate (2), pin (5) and its nut, without tightening it.

– Position the spring under the body.

– Fit : fig. V

• the rear plate securing bolts (3).

– Locate : fig. V.

• the rear securing plate by fitting :
• a locating rod, 16 mm, in a Ø at “a”,
• a locating rod 12 mm, in a Ø at “b”.

– Tighten the bolts (3) to a torque of 5 m.daN (50 Nm, 37 lbf ft).

– Fit : fig. VI

• the front plate securing bolts (1), tightening them to 5 m.daN (50 Nm, 37 lbf ft).